- Microwave combi-oven displays error code
- Fault codes in microwave combi-ovens
- Microwave combi-oven
When the software error occurs, the oven display shows an error message.
In this section, you will find a list of the problems that you can handle on your own.
|Code and description||Remedy|
F240, F439 - the touch fields on the display do not work properly.
Clean the surface of the display. Make sure there is no dirt on the touch fields.
|F601 - there is a problem with the Wi-Fi signal.|
Check your network connection. Refer to the "Before first use" chapter, Wireless connection.
|F604 - the first connection to Wi-Fi failed.|
Turn the oven off and on and try again. Refer to the "Before first use" chapter, Wireless connection.
F908 - the oven system cannot connect with the control panel.
|Turn the oven off and on.|
F131 - the temperature of the magnetron sensor is too high.
Turn the oven off and wait until it cools down.
Turn the oven on again.
|F602, F603 - Wi-Fi is not available||Turn the oven off and on.|
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.